Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - fcris

Pages: [1]
Help / Master Valve on-off for individual zones
« on: July 09, 2017, 04:26:35 pm »
Is there a way to have the master valve not go on for a single zone within a program? I would have expected a MV setting for each zone.
I could wire in a relay for that particular zone to disconnect MV power if I had to, but I'd rather not.
I pump pond water, and every other zone is a filter backwash cycle. I can't have the pump on for this cycle.

I'm switching from a Rainbird controller with this capability because I want internet - network control.


Pages: [1]