Author Topic: No hole in case for rain sensor cable or power supply wire to connect.  (Read 4466 times)

mearnhardt

  • Newbie
  • *
  • Posts: 2
    • View Profile
I am working to install my BlueSpray controller but the wiring from the various zones comes up through a conduit which was connected to my Hunter 24 Zone Controller.  The rain sensor wire ran through a hole on the top of the Hunter case but there is no hole to run the cable into the case on the bottom to wire the sensor. There was also a hole for the power cable to enter the controller case.  It appears I will need to drill a hole on the bottom of the case to run both sets of wires. Am I correct or do you have another suggestion?
« Last Edit: April 09, 2015, 01:28:52 pm by mearnhardt »

bluespray_admin

  • Global Moderator
  • Sr. Member
  • *****
  • Posts: 327
    • View Profile
The rain sensor's wires are relatively small.  Can't you route them through the cable opening on the bottom?