Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - kzsigo

Pages: [1]
1
General Discussion / Light Control
« on: July 01, 2016, 01:06:07 am »
You've posted a YouTube video on controlling 12v lights with the BlueSpray controller and I have 2 questions about it.

1. You used an expansion port and powered that port with 12V  (not clear on whether it was 12V DC or AC).  Was it required that you use an expansion port because you used 12V instead of 24V?  I have a 24 port controller and would like to control lights.

2. How much current can pass through the controller?  It would seem that to operate several lights, even LEDs, that you would quickly exceed 1amp.  Perhaps it is possible to have the current that is required to operate the lights NOT pass through the controller at all, and the controller just acts like an electronic switch?

3. How did you add a lightbulb icon? In your video, it was just there.

Pages: [1]