Messages

1

Feature Request / Re: Master Valve Control by Zone

« on: May 17, 2014, 11:47:50 am »

Thanks, I will suggest that to my irrigation person.  We're using all the zones right now so we may need to combine a couple of zones (assuming the pump can keep up) or add an expansion module.  Either way it's an interesting approach to the matter. 

2

Announcements / Re: Firmware v1.2 is released

« on: May 17, 2014, 11:44:48 am »

Thank you, email has been sent. 

3

Help / Re: New Firmware Uploaded Now Cannot Connect to Controller

« on: May 17, 2014, 11:44:27 am »

Thanks, email sent to support.

4

Announcements / Re: Firmware v1.2 is released

« on: May 16, 2014, 05:23:35 pm »

I installed this firmware and it made my controller unreachable and unusable.  Please see my post in the help section of the Forum. 

5

Help / Re: New Firmware Uploaded Now Cannot Connect to Controller

« on: May 16, 2014, 05:21:33 pm »

Since I didn't see any replies I tried to power off the controller to see if that would clear the issue.  I unplugged it for several minutes and plugged it back in, same thing.  The lights on the side are on but the system is a brick on my garage wall at this point.   

6

Help / New Firmware Uploaded Now Cannot Connect to Controller

« on: May 15, 2014, 05:17:27 pm »

I just uploaded the latest firmware and after the upload countdown the controller became unreachable via a web browser. 

I've waited five minutes with still no connection available

Any suggestions? 

7

Feature Request / Re: Garage Door Close Delay @ Close Time

« on: May 15, 2014, 04:53:48 pm »

Thank you, that would be wonderful 

8

Feature Request / Re: Master Valve Control by Zone

« on: May 15, 2014, 04:51:45 pm »

Correct.  I would like to see the option to control the master valve by zone, not as a central setting.  The increased flexibility would be great.  Right now my solution is to use two controllers with the pool being connected to my old controller and everything else from the BlueSpray.  However, that limits me from being able to remotely control the pool filler if I need to extend or cancel a run. 


Thanks

9

Bug Reports / Re: Login Popups

« on: April 05, 2014, 04:17:41 pm »

I just installed the latest firmware and that appears to have solved the issue for me.  Thanks

10

Feature Request / Master Valve Control by Zone

« on: April 05, 2014, 04:14:46 pm »

I would like to be able to set the master valve setting by zone. Here's my challenge: I irrigate my property from a well/pond setup which has the master valve to control the pump in the pond.  However, I have a zone to fill my pool which I don't want to use the well/pond water but city water.  Right now if I use my BlueSpray to control my pool filler valve it causes issues because it turns on the master valve and pond/irrigation pump which causes an overload on the circuit therefore shutting down the pump system.  If I could control the master valve by zone then I could disable it for that zone only.

Thanks!

11

Feature Request / Garage Door Close Delay @ Close Time

« on: April 05, 2014, 04:10:12 pm »

I would like to see a 4-5 min delay in the garage door closing when set to close at a time of day.  That is, I have my door set to close at 22:00 which works perfectly.  But, on occasion I come home later than that.  I would like the door to remain open for a few mins after I open when past the 22:00 hour to allow me time to back my truck in the garage without it coming down on the roof like it did last time. 

12

Help / Fuse

« on: March 30, 2014, 06:45:16 pm »

The fuse in my controller is blown.  I can't read the info on the end of the fuse.  What are the specs? Thanks

13

Bug Reports / Login Popups

« on: March 16, 2014, 08:13:18 pm »

With certain browsers on my mobile devices and my pc I receive multiple login Popups for the controller ID and Password.  In particular with Chrome and Dolphin browsers.  If I use Safari the issue seems to be less common. 

With all browsers I have to manually refresh the screen repeatedly to make all the options appear on the home screen.  This doesn't always work.

Thanks.