Topics

1

Help / My three 3 way valves need 9 "zones" to operate properly

« on: February 12, 2014, 06:39:26 am »

I find that I'm short 1 zone as I need 9 to operate the three 3 way valves.
How do I obtain and install an expansion board. I'm comfortable with electronics so am happy to fit it.

Thanks
Hilly

2

Help / 24 volt at all zones?

« on: February 12, 2014, 05:45:33 am »

I'm getting 24 volt at each zone point even though no zones are set to be on, this is wrong surely

I wanted to see if I can get the zones to run for fractions of a minute, so I used my multimeter to test it. To my surprise, all the zones 1 to 8 have 24 volt on them, even the Master valve although I set it to off.
Are there any dip switches I need to set to?

Thanks
Mike

3

Help / Can Bluespray safely handle 100 VA (4 amp draw at 24 volt) ?

« on: February 10, 2014, 06:28:54 am »

I'm wanting to use my new Bluespray controller to operate a Jandy 3 way valve actuator http://www.zodiac.com.au/jandy-valve-actuator.
Will it handle a 4 amp current draw at 24 volts?

Also do you know how to control a 3 way valve actuator?, it may require the Bluespray to operate the valve for a period  of only a few seconds... or fractions of seconds. Is this possible?

Thanks

Hilly