Messages

1

Help / I cannot connect to the unit again.

« on: February 27, 2016, 08:59:44 pm »

I cannot connect to the unit again. Unit is still watering.

All lights are working as before.

See the Hot, I  connect to the bluespray,  will not allow me access.

Cannot get access to the  BlueSpray GUI

Wasting my time on this setup is really making very unhappy with the product.

2

Help / Re: cant get back in

« on: October 25, 2015, 08:35:41 pm »

Your controller has 2.0.  You have to leave the switch down.  Once the switch is up, the
controller no longer runs the hotspot.

The way it works is when you slide the switch down, the controller operated the bluespray
hotspot for you to connect directly to provision, set up networking, etc.  When you slide
it up, the hotspot goes away, but if you've configured it to connect to you router, you can
then just access it from your network.

3

Help / Re: Unable to connect

« on: October 25, 2015, 02:47:02 pm »

I can see the Bluespray in my wifi choices, I have connected to it and it shows up as a “Bluespray limited”

I cannot access the system.

I have had this unit for about a week.
a) installed and updated to the v2. ( Chrome, Win Edge and Fox all were working )
b) working ok I think, zone 6 no longer watering.
c) had to reboot my router 10/25/15 5am, no longer can I talk to the Bluespray.
d) spent 6 hrs on the unit, ip’s, re-boot, reading forums,  I AM DONE.


Emailed Tec Support, 10/25/15 1pm

Your controller has 2.0.  You have to leave the switch down.  Once the switch is up, the
controller no longer runs the hotspot.  Doesn't your controller have instruction on the
sticker?

The way it works is when you slide the switch down, the controller operated the bluespray
hotspot for you to connect directly to provision, set up networking, etc.  When you slide
it up, the hotspot goes away, but if you've configured it to connect to you router, you can
then just access it from your network.

 

4

Feature Request / Cycle Control

« on: October 15, 2015, 09:48:52 am »

By adding a Cycle Control, would save need for so many schedules. Then a zone needs 45 minutes of water, currently to get that we need 3 schedules @ 15 minute . Cycle Control would split the time Automatically into 3 x 15 minutes.