BlueSpray Community

Techical Discussions => Bug Reports => Topic started by: indo419 on June 11, 2017, 10:42:23 am

Title: 2.1.1 Not showing Todays Runs properly & not running programs until restart
Post by: indo419 on June 11, 2017, 10:42:23 am

Since recent upgrade when i go to home page from my mobile, todays runs are all greyed and striked out.  I noticed this morning that the last run of the day that is striked out was a manual run. Seems like the whole list is from a prior day or 2 days prior when i had made a manual run.  When i restart controller from admin tab the list is corrected. This problem begins about a day after i restart. The restart day is ok the following day is not. The controller stops watering when this happens until i restart or do a manual water. New seed and vegetable garden that are supposed to water several times per day are not looking too good.
I think after upgrade it was running ok and the problem started some time after upgrade, but i am not sure.

Title: Re: 2.1.1 Not showing Todays Runs properly & not running programs until restart
Post by: bluespray_admin on June 11, 2017, 04:20:09 pm

What is your firnware's build date?

Title: Re: 2.1.1 Not showing Todays Runs properly & not running programs until restart
Post by: indo419 on June 13, 2017, 06:39:44 pm

Build date:   4/3/2017, 1:10:48 PM

Title: Re: 2.1.1 Not showing Todays Runs properly & not running programs until restart
Post by: bluespray_admin on June 13, 2017, 08:08:19 pm

Sounds like the interface was not updated. You might want to refresh the browser every time you left it for a long time.

Title: Re: 2.1.1 Not showing Todays Runs properly & not running programs until restart
Post by: indo419 on June 15, 2017, 06:30:40 pm

Hi,

Browser refresh is not the problem.

The hang just happened again.  I restarted it on 6/11 it run until yesterday as expected and did not water today at all.  I'll send you a pic.  All runs for the day are striked out up to 6pm and it is 4:20 pm now.  There has been no watering today and watering is not shown on the watering history.
Same is seen when I connect from my mobile.
Arthur

Title: Re: 2.1.1 Not showing Todays Runs properly & not running programs until restart
Post by: indo419 on July 31, 2017, 03:37:56 pm

BlueSpray continues to halt.  Been down since 7/26/17.  Today's watering is grayed/lined out, why.  SYsLog and Firmware page attached.
Is there any way to diagnose and fix this problem?
AK

Title: Re: 2.1.1 Not showing Todays Runs properly & not running programs until restart
Post by: berjer13 on February 12, 2018, 11:02:41 am

My controller also isn't running.  "Today's Runs" are grayed out/lined through.  I restarted it at the plug and through the interface but still nothing.