BlueSpray Community
General Category => General Discussion => Topic started by: PPatla on March 30, 2016, 08:26:18 pm
-
I upgraded my original box to 2.0.1 and the upgrade appeared to go fine.
The settings and programs are no longer there when I log on thru my.bluespray.net
but if I log on www.bluespray.net "account" sign in.. and then access the controller are the settings are there.
What do I need to do to see it locally?
I did a reset after the firmware upgrade.
Do I need to just reprogram the whole controller from scratch?
I am excited about being able to assign a network address instead of reserving the one assigned my DHCP.
Pat
-
I found my answer in the other forum....sorry :-)
I did the reset with the switch, reconfigured the network and it's all happy again!
Thanks!
-
I like the new timer count down feature that shows the time remaining on a running zone on the lawn view. Not sure if this applies to scheduled runs, but I see it on a manual run. I like it!