Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - howmanytimes

Pages: [1]
1
General Discussion / installation of wires to bluespray
« on: April 08, 2014, 02:53:36 pm »
Trying to install from a hunter system to Bluespary 16 zone controller.

The manual does not help to explain the correct wiring or I just do not under the instructions.

I am hoping someone could help with where which wire goes where to the Bluespray system correctly.

I attached the hunter controller (PC-300i) images of the power side wires.

SEN1, SEN2, AC2 AC1. GND is ground I know that one.  I see a COM black wire (that should match the COM in the bluespray?) and I understand all the zone wires.



BlueSpray 16 zones:

Pages: [1]