BlueSpray Community
Techical Discussions => Help => Topic started by: danowe36 on May 06, 2016, 04:40:30 pm
-
I did a reset after it was acting up again. I can connect to the network then i put in http://192.168.123.1/ and I go no ware . now i don't know what to do.
-
I finally got it to go. but now it wont start in manual mode on ipad but they do work on laptop. on the ipad i set at 10 min and hit set the zone comes on on the ipad but sprinkler don't come on. laptop work as it should hit set and it comes on.
connecting to it took a long time, i set switch to the down position, then i had to wait 15 minutes before it would let me in. when i switched it back it didn't disappear for 30 min.
-
What firmware version is your controller at now?
-
it is 2.0.2
-
If your system have master valve, running a manual on a zone from an ipad does not work because it doesn't provide you a master valve selection. Tap on the water icon should work.
-
apparently the update dose not have this option. it worked before the update. when i need to winterize it is going to suck.