Topics

1

Help / Entered wrong server info now cannot access

« on: June 28, 2015, 05:41:46 pm »

Ok so the instructions were not clear in the box on setup and when I connected to the bluespray network I entered the incorrect information for the server. Actually I did not enter anything and did not set up a username or a password. Now I am trying to access the controller again through the bluespray network after resetting it several times by moving the switch down for 15 seconds then back up. When I rejoin the bluespray network and enter the 192.168.1.1 local URL it asks for a username and password which I did not set up so I cannot access it and am not able to get it to reset to factory. Please advise. Hopefully once connected I can forward the ports to access from outside home network but the most important thing for me is to upgrade to the new firmware to be able to add a station delay for my well water to recharge and have enough pressure to run.