BlueSpray Community
Techical Discussions => Help => Topic started by: mearnhardt on April 09, 2015, 01:14:34 pm
-
I am working to install my BlueSpray controller but the wiring from the various zones comes up through a conduit which was connected to my Hunter 24 Zone Controller. The rain sensor wire ran through a hole on the top of the Hunter case but there is no hole to run the cable into the case on the bottom to wire the sensor. There was also a hole for the power cable to enter the controller case. It appears I will need to drill a hole on the bottom of the case to run both sets of wires. Am I correct or do you have another suggestion?
-
The rain sensor's wires are relatively small. Can't you route them through the cable opening on the bottom?