1
Help / Upgrade to 2.0.2, unit no longer responding at all
« on: May 22, 2016, 11:46:51 am »
Unit was not responding to any commands when trying to do manual watering (running 2.0). reboot, etc didn't clear issue. Saw there was a 2.0.2 available, so decided to roll the dice.... again.
Now the unit will not respond at all. I've tried the reset procedure (slide down for 5 seconds, wait for amber light to blink - never happens). I've tried stand-alone mode (slide down for >30 seconds - nothing happens and no hotspot). When power cycling the device, I get all 3 lights on, blue flashes for a bit then turns off (leaving green and amber lit), then amber turns off shortly after (leaving green lit).
Any suggestions?
Now the unit will not respond at all. I've tried the reset procedure (slide down for 5 seconds, wait for amber light to blink - never happens). I've tried stand-alone mode (slide down for >30 seconds - nothing happens and no hotspot). When power cycling the device, I get all 3 lights on, blue flashes for a bit then turns off (leaving green and amber lit), then amber turns off shortly after (leaving green lit).
Any suggestions?